| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Dimensions of Delta Bandsaw Enclosed Base Cabinet Required http://www-.luthiersforum.com/forum/viewtopic.php?f=10101&t=44296 |
Page 1 of 1 |
| Author: | Mick Oliveira [ Mon Oct 06, 2014 11:03 pm ] |
| Post subject: | Dimensions of Delta Bandsaw Enclosed Base Cabinet Required |
I realize that this isn't specifically a luthier related question but I recently acquired a Delta Bandsaw Model 28-206 without the enclosed base cabinet. I would like to make an enclosed base cabinet of the same exact dimensions as the original out of MDF but I am having trouble locating the measurements. If anyone here on the forum has a Delta Bandsaw with the Enclosed base cabinet I would appreciate a hand with this. Thanks |
|
| Author: | TonyKarol [ Tue Oct 07, 2014 5:29 pm ] |
| Post subject: | Re: Demensions of Delta Bandsaw Enclosed Base Cabinet Requir |
Hey Mick .. I have a Delta that had an open base .. and converted it to a closed one, with an even smaller footprint !!! .. come on up and check it out ... |
|
| Author: | Jim Kirby [ Tue Oct 07, 2014 5:38 pm ] |
| Post subject: | Re: Demensions of Delta Bandsaw Enclosed Base Cabinet Requir |
18" wide, 16" deep, 25" high. That's a 28-212 saw, though, an American one from I think the last yaer they made them. Originally had a 1 horse motor. |
|
| Author: | Mick Oliveira [ Tue Oct 07, 2014 6:52 pm ] |
| Post subject: | Re: Demensions of Delta Bandsaw Enclosed Base Cabinet Requir |
Sounds good. I will PM you. TonyKarol wrote: Hey Mick .. I have a Delta that had an open base .. and converted it to a closed one, with an even smaller footprint !!! .. come on up and check it out ...
|
|
| Author: | Jim Kirby [ Tue Oct 07, 2014 8:10 pm ] |
| Post subject: | Re: Demensions of Delta Bandsaw Enclosed Base Cabinet Requir |
I was going to take a pic or two of mine to check that it's what you want but I cribbed this off the internet instead. Same saw, same base. Attachment: 55076d1402618345t-delta-28-212-14-bandsaw-2012-11-11-19.38.47.jpg
|
|
| Author: | Mick Oliveira [ Tue Oct 07, 2014 8:28 pm ] |
| Post subject: | Re: Demensions of Delta Bandsaw Enclosed Base Cabinet Requir |
Jim Kirby wrote: I was going to take a pic or two of mine to check that it's what you want but I cribbed this off the internet instead. Same saw, same base. Attachment: 55076d1402618345t-delta-28-212-14-bandsaw-2012-11-11-19.38.47.jpg Jim, I appreciate your help. Yes that's the one. Thanks for the dimensions. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|